Kansai Electric Heat Corp. |High-blow nozzle SUS | Low pressure loss! Low cost! Light!

Catalog No.10-3

Low pressure loss! Low cost! Light!

High efficiency

　High-blow nozzle SUS

Compressor and high pressure blower are unnecessary!
Air-speed 100m/s can be discharged by the turbo-blower

Rapid removing water

Rapid drying

Removing powder

Air-curtain

Even surface treatment

Cooling

Drying before ink-jet

Removing condensation

	Simple inside rectification structure			*Slit width adjustment type*

	Material is Stainless SUS304 2B type			Hexagon pin spanner for adjustment slit width is equipped.

Specification
*Model*	*50SUS*	*65SUS*	*75SUS*	*100SUS*	*125SUS*
Bore of the inlet	φ50	φ65	φ75	φ100	φ125
Adjustment range of slit width	0.5 - 1.5mm	1.0 - 2.0mm	1.0 - 2.mm	1.0 - 3.0mm	1.0 - 4.0mm
Manufacturable slit length	・200mm - 1000mm at slit width 0.5 - 1.0mm	・300mm - 1900mm at slit width 0.5 - 1.0mm ・300mm - 1000mm at slit width 1.1 - 2.0mm	・300mm - 1900mm at slit width 0.5 - 1.0mm ・300mm - 1500mm at slit width 1.1 - 2.0mm	500mm - 2400mm	500mm - 2400mm
Efficient use air-speed	・25m/s - 120m/s at slit width 1.0mm ・25m/s - 100m/s at slit width 1.5mm	・25m/s - 120m/s at slit width 1.0mm ・25m/s - 100m/s at slit width 2.0mm	・50m/s - 150m/s at slit width 1.0mm ・25m/s - 80m/s at slit width 2.0mm	・50m/s - 150m/s at slit width 1.0mm ・25m/s - 80m/s at slit width 2.0mm ・25m/s - 50m/s at slit width 3.0mm	・25m/s - 150m/s at slit width 1.0mm ・25m/s - 100m/s at slit width 2.0mm ・50m/s - 100m/s at slit width 3.0mm ・50m/s - 75m/s at slit width 4.0mm
Heatproof temp.	Less than 350C
Resisting pressure	Less than 49kPa
Accuracy rating	Disorder of the air-speed of the right and left is less than plus minus 5% (Except 25mm of the slit both ends)
Category	Standard	Standard	Standard	Standard	Standard

Kansai Electric Heat Corp.

4-18, Takaidanishi 5-chome, Higashiosaka-city 577-8566 JAPAN

TEL : +816-6785-6001　FAX : +816-6785-6002

E-mail ： sales@kansaidennetsu.co.jp